Electrical Connections - Erreka AM600S Manual Del Instalador

4

ELECTRICAL CONNECTIONS


Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, and always earthed.

Check the manufacturer's instructions for all the elements installed.

General connections
R.E Plug-in receiver
ANT Cable connectors for antenna
SMF Traffic light card AEPS1-001
PUL1 Close mini-pushbutton
PUL2 Open mini-pushbutton
A.T Total opening key command
A.P Pedestrian opening key command
SG.A Opening safety device (mechanical strip or
photocell)
SG.C Closing safety device
(photocell or mechanical strip)
FCC Closing limit switch
FCA
Opening limit switch
(photocells without testing)
(photocells with testing)
AUX Output (24Vdc, 300mA)
Constant output in order to feed peripheral
devices (photocells without testing)
FT 24Vdc Output for photocell testing. Testing
pulse output
E1 A1 Operator (ORION, RINO) encoder cable
connectors
STOP Emergency pushbutton
LG Garage light
(230Vac: max. 2,300W resistive)
(125Vac: max. 1,250W resistive)
DEST Flashing light
(125/230Vac, max. 60W)
M A1 Operator motor
C A1 Operator capacitor
INSTALLATION
Control board AM600S-AM606S
23