Idiomas disponibles
Idiomas disponibles
EN
Malfunction analysis
ee
Please check below items before asking for maintenance.
lf the malfunction still can't be eliminated, please contact
se, it
local dealer or qualified professionals.
Phenomenon
ndition-
Air
r the
conditioner
refer to
can't
bly of
operate
ocked.
te
Poor
cooling
at
(heating)
ed.
oner.
r to the
Air
or not. lf
conditioner
can't
receive
signal from
remote
e,
control or
remote
control is
hassis
not
sensible
event
als.
You can
n.
heard the
please
sound of
nter for
"PAPA"
There's
abnormal
sound during
operation
There's off
flavour
Check items
Solution
Power failure?
Wait after power recovery.
Reinsert the plug.
Is plug loose?
Ask professional pe-
Whether the air
rson to replace air
switch is tripped off
or fuse is burnt?
switch or fuse.
ls there malfunction
Ask professional per-
for the circuit?
son to replace circuit.
Whether the unit is
Wait for 3min, and
restarted up after st-
then turn on the unit
opping immediately?
again.
Wait after voltage is
Is the power too low?
resumed.
Whether the air filter
Clean the air filter.
is too dirty?
Whether the set tem-
Adjust the tempera-
perature is proper?
ture.
Whether door and
Close door and
window are closed?
window.
Whether the unit is
Please pull out the
interfered seriously
plug. Insert the plug
(such as static pre-
after about 3min, and
ssure, unstable
then turn on the unit.
voltage)?
The receiving range
Whether remote co-
of remote controller
ntroller is within the
is 8m. Do not exceed
receiving range?
this range.
Whether it's blocked
Remove the obstacles.
by obstacles?
Check the batteries
Is sensitivity of rem-
of remote controller.
ote controller low?
If the power is low,
please replace the
batteries.
Move the remote co-
Whether there's flu-
ntroller close to air
orescence lamp in
conditioner.
the room?
Turn off the fluoresc-
ence lamp and try it
again.
Heat expansion or
Whether the unit is
shrinkage for the
turned on or turned
panel due to change
off just now?
of temperature, which
cause friction sound.
Disconnect power,
Whether the unit is
put through the power
interfered by thunder,
again, and then turn
radio, etc?
on the unit again.
There's off-flavour
Eliminate the
source in the room,
off-flavour source.
such as furniture,
Clean the filter.
cigarette etc.
Phenomenon
Check items
Whether air outlet or
air inlet is blocked?
Under heating mode,
whether indoor temp-
erature increase set
temperature? ( IPE
-1221GH Model only)
No air blowed
Whether heating
out from air
mode is started up
conditioner
just now? ( IPE -
1221GH Model only)
Whether evaporator
is defrosted? (obser-
ve it by pulling out
the filter)
Whether the unit op-
erates under auto
Set tempe r-
mode?
ature can't
Whether the requir-
be adjusted.
ed temperature
exceeds the temp-
erature setting range?
You can heard
Whether the unit is
water-flowing
turned on or turned
sound
off just now?
Malfunction code
Error code
Please contact qualified professionals for
F1、 F2 F4 F0
service.
1.Check if the unit is under high-temperature
and high-humidity environment; if ambient
temperature is too high, power off the unit
and then energize it for operation after the
ambient temperature drops to 35°C(95°F）
below.
E8、 H3
2.
Check if the evaporator and condenser
are blocked by some objects; if yes, take
away the objects, power off the unit and
then energize it for operation.
3.If the malfunction still occur, please co-
ntact our after-sales service center.
1.
Pour out the water inside chassis.
2.
If "H8" still exist, please contact profess-
H8
ional person to maintain the unit.
WARNING
If there're following phenomenon, please turn off the air
conditioner and disconnect the power immediately, and
Iris Ohyama France SAS Customer Service Center.
Iris Ohyama France Customer Service E-mail
●
Power cord is overheating or damaged.
sound during operation.
Do not repair or refit the air conditioner by yourself.
If operate the air conditioner under abnormal condition, it
may cause malfunction, electric shock or fire hazard.
9
Solution
Eliminate the obstacles.
The unit will stop blo-
wing fan after reaching
set temperature.
In order to prevent cold
air, air conditioner will
delay for a while to be
started up, which is the
normal phenomenon.
It's the normal pheno-
menon. Air conditioner
is defrosting. After de-
frosting is finished, it
will resume operation.
Temperature can't be
adjusted under auto
mode.
Temperature setting
range: 16°C(61°F） -
30°C(86°F）
There's flowing sound
of refrigerant inside
the air conditioner,
which is the normal
phenomenon.
Troubleshooting
●
Abnormal
●
Off-flavor.
●
Water leakage.
EN
