Idiomas disponibles
Idiomas disponibles
B
Using the appliance
To show the remaining program time and delay time, error
code etc.
Rinse Aid
If the "
" icon is lit, it means the dishwasher is low on
dishwasher rinse aid and requires a refill.
Salt
If the "
" icon is lit, it means the dishwasher is low on
dishwasher salt and needs to be refilled.
Water Faucet
10
Screen
If the "
" icon is lit, it means the water faucet closed.
Upper
When you select Upper, only the dishes in the upper rack will
be washed. The spray system of the lower basket will not
operate.
Lower
When you select Lower, only the dishes in the lower rack will
be washed. The spray system of the upper basket will not
operate.
Self-
This program provides an effective cleaning of the dishwasher
11
cleaning
itself.
Turbo
Reduce the program time. (It can only be used with Hygiene
12
speed+
72˚C, ECO, Glass, 90min, 58min.)
Extra
For better drying result. (It can only be used with Hygiene
13
Drying
72˚C, ECO, Glass, 90min, 58min.)
After washing, the door will open automatically to achieve
better drying effect.(It can only be used with Auto Hygiene
Auto
72˚C, ECO, Glass, 90min, 58min, Self-cleaning.)
14
open
The button will light on when above programs are selected.
You can cancel the auto-open function by pressing this button
before pressing the START button, then the light will be off.
Press the button to select either upper basket or lower basket
15
Alt
loaded, and the corresponding indicator will light up.
Press the "-" button to decrease the delay time, maximum 24
16
Delay -
hours delay can be defined.
17
Delay +
Press the "+" button to add the delay time.
28
EN
B
Using the appliance
This option allows you to lock the buttons on the control panel,
so children cannot accidently start the dishwasher by pressing
Child
18
the buttons on the panel. Only the Power button remains
lock
active. To lock or unlock the buttons on the control panel,
press this button for 3 seconds .
Start
To start the selected washing program or pause it when the
19
Pause
dishwasher is working.
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Self-cleaning for more
than 5 seconds to enter the water softener setting mode.
3. Press the Self-cleaning again to select the proper set according to your local environment,
the setting will change in the following sequence: H3->H4->H5->H6->H1->H2;
4. Without operation in 5 seconds or press the Power button to complete the setup and exit
the setup mode.
29
EN
