Idiomas disponibles
Idiomas disponibles
EN
1. Remove the rubber seal (1) and the release valve
tool (2) from the jack.
English (Original Instructions)
1
2
2. Insert release valve tool into the release valve.
3. Slowly turn the release valve tool counterclockwise
to release pressure, allowing the piston to be
retracted.
Note: When using the release valve, the load of the
vehicle will lower the piston. There may be slight
pressure needed to fully lower the piston.
4. Once the piston has retracted enough to remove
the jack from under the vehicle, tighten the release
valve by turning the release valve tool clockwise.
6
MAINTENANCE
When servicing, only use greenworks
recommended replacement parts. Use of any other
parts could create a hazard or cause product
damage and will void the warranty.
6.1
GENERAL MAINTENANCE
•
This product does not require an oil change during
its lifespan.
•
Maintenance and repair must be carried out by
qualified persons.
•
Regularly clean the exterior of the product. Avoid
using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various
types of commercial solvents. Use clean cloths and
warm soapy water to clean the plastic components.
•
Before each use, turn the product on and check that
all functions are working correctly.
10
WARNING
®
