Idiomas disponibles
Idiomas disponibles
- Switch II: medium power
- Switch I+II: maximum power
- Turn the thermostat control to the
desired temperature position.
- During the appliance's use the
pilot light will come on and off
automatically, indicating the heating
elements are working, and therefore
maintaining the desired temperature.
Once you have finished using the
appliance:
- Select the minimum position (MIN)
using the thermostat control.
- Turn off the appliance, using the
power selection switches.
- Unplug the appliance from the
mains.
- Put the cable back in the cable
housing.
- Put on the protective cover.
Carry handle/s:
- This appliance has a handle on
the upper part of the body, which
facilitates comfortable transportation.
Safety trip switch:
- The appliance has a safety trip
switch that protects the appliance
from overheating.
- When the appliance switches itself
on and off repeatedly, for reasons
other than the thermostat control,
check to ensure that there are no
obstacles that impede correct air
entry or expulsion.
- If the appliance turns itself off and
Manual Tuareg.indd 15
does not switch itself on again,
disconnect it from the mains supply,
and wait for approximately 15
minutes before reconnecting. If the
machine does not start again seek
authorised technical assistance.
Cleaning
- Unplug the appliance from the
mains and let it cool before starting
any cleaning.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
- Do not let water or any other liquid
get into the air vents to avoid damage
to the inner parts of the appliance.
- Never submerge the appliance in
water or any other liquid or place it
under running water.
anomalies and repair
- Take the appliance to an authorised
technical support service if problems
arise. Do not try to dismantle or repair
without assistance, as this may be
dangerous.
- If the connection to the mains has
been damaged, it must be replaced
and you should proceed as you would
in the case of damage.
24.05.07 18:41:11
