Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, allow the
oven to cool completely and then wipe it with a cloth
or sponge.
CLEANING THE CATALYTIC PANELS
This oven is equipped with special catalytic liners that
facilitate cleaning of the cooking compartment thanks
to their special self-cleaning coating, which is highly
porous and able to absorb grease and grime. These
panels are fitted to the shelf guides: When repositioning
and then refitting the shelf guides, make sure that the
hooks at the top are slotted into the appropriate holes
in the panels.
REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
2. Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
10
Carry out the required
operations with the oven cold.
Disconnect the appliance from
the power supply.
• The door can be easily removed and refitted to
facilitate cleaning of the glass.
• Clean the glass in the door with a suitable liquid
detergent.
• The top heating element of the grill can be lowered
to clean the upper panel of the oven .
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
To make best use of the catalytic panels' self-cleaning
properties, we recommend heating the oven to 200 °C
for around one hour using the "Convection Bake"
function. The oven must be empty during this time.
Then leave the oven to cool down before removing any
remaining food residues using a non-abrasive sponge.
Please note: Using corrosive or abrasive cleaning agents, stiff
brushes, pan scourers or oven sprays could damage the
catalytic surface and compromise its self-cleaning properties.
Please contact our After-sales Service if you require
replacement panels.
Put the door to one side, resting it on a soft surface.
3. Refit the door by moving it towards the oven,
4. Lower the door and then open it fully.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
~60°
aligning the hooks of the hinges with their
seating and securing the upper part onto its
seating.
Lower the catches into their original position:
Make sure that you lower them down completely.
~15°
b
a
