cecotec ENERGYSILENCE 3000 Manual De Instrucciones página 18

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1.
1. Control panel
2. Front air outlet
3. Power cord
Control panel
Fig. 2.
1. Timer
2. Speed
3. Oscillation mode
4. Mode
5. On/Off button
2. BEFORE USE
Take all the product components out of the box and make sure all of them are included and in
good conditions.
If any sign of visible damage is observed, contact immediately with our official Technical
Support Service.
3. OPERATION
Place the fan on a dry, level surface.
Connect the appliance to the power supply.
To turn the fan on, press the On/Off button.
Speed
Press the speed button repeatedly to set the desired speed setting: Press once to set low
speed, press twice to set medium speed and 3 times to set high speed. The LED indicator will
light up according to the speed level set.
Oscillation
Press this button to activate the oscillation mode. The corresponding LED light will remain lit
up.
Timer
Pres the timer button repeatedly to activate the timer. Select 0.5, 1, 2, 4 hrs and combine them
34 ENERGYSILENCE 3000 DESKTOWER CONTROL
up to a maximum of 7.5 hrs. The corresponding LED light will remain lit up. Once the selected
time has elapsed, the device will turn automatically off.
Modes
Natural breeze
Press the mode button once for the fan to generate a natural breeze. The fan speed will vary
automatically according to the below cycles.
When the Natural breeze mode is activated from the fan or the remote control, you can select
one of the 3 levels: P3, P2 or P1:
P3 cycle: Medium-low-high-medium-low-high-off.
P2 cycle: Low-medium-low-off.
P1 cycle: Low-off.
Sleep mode
The cycles are the same as the Natural breeze mode ones, but times differ.
After setting the Sleep mode, press the SPEED button to set one of the 3 levels.
P3: It will run the first half an hour in P3 cycle, then another half an hour in P2 cycle and then it
will switch to cycle P1 until the fan turns off or until the timer elapses.
P2: It will run the first half an hour in P2 cycle and then it will switch to cycle P1 until the fan
turns off or until the timer elapses.
P1: It will run in cycle P1 until the fan turns off or until the timer elapses.
Press the mode button a third time to turn both previous modes off.
The corresponding LED light will light up while a mode is activated.
All these functions can also be activated from the remote control.
Fig. 3
1. On/Off button
2. Speed
3. Oscillation
4. Timer
5. Mode
Note: The fan will not operate when the timer is not set to any time, even if the speed settings
are configured.
ENERGYSILENCE 3000 DESKTOWER CONTROL
ENGLISH
35