Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fitting the nozzle or nozzle disc combination
How to proceed:
C
Place the riser pipe onto the propeller unit, and fasten using the screws and washers.
Place the desired nozzle or nozzle disc combination (overview of spray patterns) including protection grid and O-ring
onto the riser pipe, and fasten using the screws, washers and nuts.
– Spray pattern III: Place the disc onto the propeller such that the grub screws at the propeller and the bore holes in
the disc are congruent one on top of the other. Fasten the disc with the screw.
Fitting the float body
If an optionally available spotlight set is to be attached to the unit, the spotlight set has to be mounted first. After that fit
the float body. (→ Installation of optional lighting set)
How to proceed:
D
Place the float body onto the propeller unit.
Turn the float body clockwise up to the stop (until the fastening flanges are visible).
Fasten the float body onto the fastening flanges using the screws, washers and nuts.
Fitting the float body
If an optionally available spotlight set is to be attached to the unit, the spotlight set has to be mounted first. After that fit
the float body. (→ Installation of optional lighting set)
How to proceed:
E
Place the float body onto the propeller unit.
Fasten the float body onto the fastening flanges using the screws, washers and nuts.
Installation of optional lighting set
Max. three spotlight sets can be mounted on the unit. The spotlight sets are not part of the scope of delivery but are
available as accessories.
• LED floating fountain spotlight (Art. 42637) or LunAqua 10 LED (Art. 50479).
Prerequisite:
• The float body is not fitted.
Fitting the transformer
How to proceed:
L
Fasten the transformer onto the transformer mounting plate using the screws, washers and nuts.
Fasten the transformer mounting plate onto the propeller unit using the screws, washers and nuts.
Fitting the float body(→ Fitting the float body)
Fitting the spotlights
How to proceed:
M
Connect the plug of the connection cable, and turn in and firmly tighten the screws.
Fasten the spotlight holder to the lighting unit using the clamping screws and square nuts.
Fasten the spotlight holder to the float body using the screws and washers.
Connect three spotlights each to one transformer (for this remove the screws from the transformer and take off the
cover cap, connect the plug of the connection cable to the transformer, and turn in and tighten the screws).
– Avoid kinking the connection cables. If necessary, bundle connection cables together using cable binders.
- EN -
19
Tabla de contenido
