Toro 51487 Manual Del Operador página 10

Charging the Battery Pack
Important: For best results, your battery tool should be
charged in a location where the temperature is more than
41 degrees F (5 degrees C) but less than 104 degrees F (40
degrees C). To reduce the risk of serious personal injury,
do not store outside or in vehicles. Charging time will be
increased if not charged within this range.
1. Turn the battery upside down and line up the battery terminal
with the slot in the charger (Figure 12 and Figure 13).
1
1. LED indicators
3
1. LED indicators (level of
charge)
2. Release button
2. Slide the battery into the charger until it clicks into place.
3. To remove the battery, press down on the release button
and slide the battery backwards out of the charger.
2
G017407
Figure 12
2. Insert battery here
2
G016223
Figure 13
3. Battery terminal
4. Refer to the table below to interpret the LED indicators on
the battery charger.
LED COLOR
Left Right
Red Red
Red Green
Red Orange
Red
Green
Red (blinking) Red (blinking)
Advancing the Line
The trimmer is equipped with an auto-feed head. The line will
advance 6 mm (1/4 inch) each time you stop and start the
trimmer. When the line reaches the blade in the deflector, it will
be cut off at that length.
1. With the trimmer running, release the switch trigger.
2. Wait two seconds, then press the switch trigger.
3. Resume trimming.
Advancing the Line Manually
Disconnect the string trimmer from the power supply, then push
the red button at the base of the spool retainer while pulling on the
trimmer line to manually advance the line.
1
1. Button
10
Indicates:
Battery is charging
Fully charged
Battery is too
warm: Remove
for approximately
30 minutes
No battery present
Defective battery
Figure 14