English
Set the high temperature limit
stop (optional)
Remove the screw cover, located on the back of
the handle.
Use a 4 mm allen wrench to loosen the screw.
Remove the handle
Remove the flange and the green high tempera-
ture limit stop ring.
Install the high temperature limit stop ring so that
the black positioning pin is in the notch corre-
sponding to the desired high temperature.
The temperatures shown in the diagram assume an
incoming cold water temperature of 50°F and an
incoming hot water temperature of 140°.
Center and replace the flange.
Replace the handle.
Tighten the screw.
Replace the screw cover.
6
