Idiomas disponibles
Idiomas disponibles
To use LevelOne WBR-5400 correctly, you have to properly configure the network settings of your computers and
install the attached setup program into your MS Windows platform
Make Correct Network Settings of Your Computer
The default IP address of this product is 192.168.123.254, and the default subnet mask is 255.255.255.0. These
addresses can be changed on your need, but the default values are used in this QIG. If the TCP/IP environment of your
computer has not yet been configured, you can refer to Appendix A in User`s manual to configure it. For example,
1. Configure IP as 192.168.123.1, subnet mask as 255.255.255.0 and gateway as 192.168.123.254, or more
easier,
2. Configure your computers to load TCP/IP setting automatically, that is, via DHCP server of this product.
LevelOne WBR-5400 provides Web based configuration scheme, that is, configuring by your Web browser. This
approach can be adopted in any MS Windows, Macintosh or UNIX based platforms.
Start-up and Log in(Fig 2)
Activate your browser, and disable the proxy or add the IP address of this product into the exceptions. Then, type this
product's IP address in the Location (for Netscape) or Address (for IE) field and press ENTER. For example:
http://192.168.123.254.
After the connection is established, you will see the web user interface of this product as Fig2. There are two
appearances of web user interface: for general users and for system administrator.
To log in as an administrator, enter the system password (the factory setting is "admin") in the System Password field
and click on the Log in button. If the password is correct, the web appearance will be changed into administrator
configure mode. As listed in its main menu, there are several options for system administration.
Wizard(Fig 3)
Setup Wizard will guide you through a basic configuration procedure step by step.
2 Network Settings
6
