Troubleshooting; Scrapping - Advance ecoflex SC3000 26” Disc Instrucciones De Uso

ENGLISH

TROUBLESHOOTING

TROUBLE
The motors do not work; no warning light turns on. The battery connector is disconnected.
The machine does not move and the display (71)
shows the error code:
At the machine start-up, the LED (68) of the
switch (67) fl ashes and the brushes do not work.
The brushes do not work; the red warning light
fl ashes.
The 3 warning lights (62) fl ash simultaneously.
The display (71) shows an error code as:
where "00" is replaced by a code different from
"t4".
The dirty water vacuuming is insuffi cient.
The solution fl ow is insuffi cient.
The squeegee leaves marks on the fl oor.
NOTE
The machine cannot operate without the battery charger.
In case of battery charger malfunction, contact an authorized Service Center.
For further information, refer to Advance Service Centers.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
30
INSTRUCTIONS FOR USE
The batteries are discharged.
The machine has been turned on by using the
ignition key and by keeping the pedal pressed.
The machine has been turned off without
lifting the brush deck.
The batteries are discharged.
The brush motors are overloaded.
There are foreign materials (tangled threads,
etc.) preventing the brushes from rotating.
The machine electronic control system is in
alarm condition.
The recovery tank is full.
The vacuum grid is clogged or the fl oat is
closing.
The container with debris collection grid is
clogged.
The hose is disconnected from the squeegee
The squeegee is dirty, or the squeegee blades
are worn or damaged.
The tank cover is not properly closed, or the
gasket is damaged.
The solution tank is empty.
The solution fi lter is dirty
The EcoFlex™ system tank is dirty/encrusted. Drain.
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee is not balanced with the
handwheel.
9098827000(2)2010-12
POSSIBLE CAUSE
SC3000 26" Disc / 28" Cyl.
REMEDY
Connect.
Charge the batteries.
Release the drive pedal.
If the problem persists, contact an authorised
Service Center.
Wait for the deck to lift before turning on again
the brushes by pressing the switch.
Charge the batteries.
Use less aggressive brushes and/or avoid
working with extra pressure turned on.
Clean the brush hubs.
Turn off the machine and then turn it on again.
If the problem persists, contact an authorised
Service Center.
Empty the tank.
Clean the vacuum grid.
Clean.
Connect.
Clean the squeegee or overturn/replace the
blades.
Correctly close the cover or clean/replace the
gasket.
Fill.
Clean the fi lter.
Remove the debris.
Overturn or replace the blades.
Adjust the squeegee.