Cleaning The Debris Bag - Pentair BLUEFURY Guia De Instalacion

Cleaning the Debris Bag

1. Detach the bag strap from the hose.
2. Press the release button on the cleaner vacuum tube and carefully pull up to remove the bag from the cleaner.
See figure 16.
3. Open bag closure by pulling apart the fabric tabs at the top of the bag. Holding the bottom of the bag, turn
over to empty debris out of the top. If needed, rinse bag with a hose.
4. To close, press together the hook and loop fabric at the top of the bag and run finger along entire length of
bag so it is completely closed.
5. Be sure debris seal is on the vacuum tube. See figure 14 on previous page.
6. Slide the debris bag collar over the vacuum tube until it clicks in place.
7. Re-attach the strap onto the feed hose.
8. To keep bag from folding during operation, attach the strap above first feed line float. Slide float down if needed.
Note: It is easier to empty the debris bag when it is dry. A second bag (purchased separately) may be used
while the used debris bag is drying.
371674 (REV 02/2014)
Use tabs to pull
bag apart
Figure 16.
Debris Bag
Bag Release
Button
11