Cleaner Components - Pentair BLUEFURY Guia De Instalacion

Cleaner Components

1. BLUEFURY™ Cleaner Head
2. Debris Bag
3. Sweep Hose (not needed in most
pools)
4. Feed Hose Assembly - Not shown
(3 x 3m. or 3x 10ft. sections)
5. Wall Fitting
6. Wall Adapter
7. Debris Seal
Note: The cleaner system is delivered with
debris seal installed inside of cleaner head.
8. Flow Gauge
Overview
The BLUEFURY™ Pressure Side Pool Cleaner moves
through a sequence of straight, right and left turns
helping to increase pool coverage, vacuuming and
scrubbing your entire pool.
• For continuous uninterrupted cleaning, the cleaner
will go into reverse mode about every two minutes,
which allows it to efficiently clean the entire pool.
Note: Before you install and operate your cleaner,
read through these important guidelines:
1. Always disconnect the cleaner from the pool wall
when cleaning or back washing the pool filter.
2. After cleaning or back washing the filter, let the
filtration system run for at least five minutes before
reconnecting the cleaner.
3. New plumbing lines should be flushed out before
installing the cleaner.
4. The cleaner should not be used to remove plaster
dust in new pools.
5. Always remove the cleaner before swimmers enter
the pool.
6. Always handle the cleaner with care.
7. Always pick up the cleaner by the handle,
especially when lifting the unit out of the water.
8. Do not handle the cleaner while it is operating.
9. Always remove the cleaner from the pool before
chemical shock treatments (super chlorinate). As a
rule, any pool water that is unsafe for swimming is
unsafe for the cleaner.
371674 (REV 02/2014)
6
5
8
10. Carefully cut the feed hose following the
instructions.
11. By following these simple guidelines, you can help
protect against injury and prolong the life of your
cleaner.
12. Refer to "Important Warning And Safety
Instructions" for additional installation and safety
information.
OVERVIEW
3
Night Cruize ™ LED
4
2
7
1