Vacuum Cleaner Description; Vacuum Cleaner Parts And Labels; Optional Kits; Accessories - Nilfisk T75 Manual De Instrucciones

T75

Vacuum Cleaner Parts and Labels

1.
Identification plate which includes:
Code of the Model, Technical Specifications (see table
on page 6), Serial N°., EC Mark, Year of manufacture,
Nominal network voltage.
2. Vacuum union hose
3.
Control panel
4. Vacuum gauge
5. Dust container
6. Filtering chamber
7.
Outlet
8. Attention plate
Draws the operator's attention to the fact that the filter
must only be shaken when the vacuum cleaner is turned
OFF (see also par. "Primary filter shaker").
9. Panel power plate
Indicates that the panel is powered by the voltage
indicated on the data plate.
10. Inlet
11. Accessories compartment
This vacuum cleaner creates a strong air flow which is drawn
in through the inlet (10) and blows out through the outlet (7).
Before turning the vacuum cleaner on, fit the vacuum hose
into the inlet and then fit the required tool on to the end part.
Refer to the manufacturer's accessory catalogue or Service
Centre. After the hose and tools have been fitted, make sure
that the motor turns correctly.
This vacuum cleaner is equipped with an internal baffle
plate which subjects the vacuumed substances to a circular
centrifugal movement that makes them drop into the
container. The vacuum cleaner is equipped with a filter which
enables it to be used for the majority of applications.

Optional kits

Please contact the manufacturer's sales network for
information on optionals.
GB
Instructions for installing the optional are included in the
conversion kit.
Use only genuine optional kits supplied and
authorized by the manufacturer.

Accessories

Various accessories are available; refer to the manufacturer's
accessory catalogue.
Use only genuine accessories supplied and authorised
by the manufacturer.
C360

Vacuum cleaner description

Figure 1
WARNING!
WARNING!

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Model A (mm)
T75 1850

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight).
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection cables
must be protected against splashes of water.
■ Check that for proper connection to the electrical
mains.
■ Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical mains
by removing the plug (do not pull the cable).
■ Only replace the electric power cable with one of
the same type as the original: H07 RN - F. The same
rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
4
Figure 2
B (mm) C (mm)
1350 700 220
07/2018
Kg