Faro MAIA Manual De Uso página 21

INSTRUCTIONS FOR USE
SWITCHES SYMBOL
"MAIA" LAMP WITH SWITCH (see description of the parts)
On/Off/Adjustment
- To switch on or off, press and release the command lever to the left or right.
- Adjustment:
a) On command: (1 beep)
b) To reduce light intensity, hold the command lever (on rear of lamp) to the left until
the desired intensity is reached. When the minimum intensity is reached you will hear
an acoustic signal (1 beep).
c) To increase light intensity, hold the command lever (on rear of lamp) to the right until
the desired intensity is reached. When the maximum intensity is reached you
will hear an acoustic signal (1 beep).
"MAIA" LAMP WITH PROXIMITY SWITCH (see description of the parts)
On/Off
- To turn the lamp on and off, place your hand close to the sensor, within a maximum
distance of 3 cm. When the command is given, an acoustic signal will be heard (1 beep).
- For light intensity regulation, place the hand near the sensor until desired intensity is
reached, from the maximum to the minimum level and from the minimum to the maximum
level. On reaching maximum intensity, an acoustic signal will be heard (1 beeps); there
will be 1 beep for minimum intensity.
"MAIA" LAMP WITH REMOTE CONTROL DEVICE (see description of the parts)
Remote cable length 4 m – Maximum range from arm on the side of the pin: 2.5 m.
On/Off/Adjustment
- To turn the lamp on and off, press and release button "A".
- Adjustment:
a) to reduce the light intensity, keep button "A" pressed until the desired level of
intensity is reached. When the minimum level of intensity is reached, an acoustic
signal will be heard (1 beep).
When the minimum light intensity is obtained, you will hear an acoustic signal (1 beep).
b) To increase the light intensity keep the push-button "A" pressed, until the desired
intensity is obtained.
When the minimum light intensity is obtained, you will hear an acoustic signal (1 beep).
Each time the lamp is turned on, the light intensity will be at the level memorised when
it was turned off the time before.
BUTTON B IS NOT ENABLED.
20
Each time the lamp is turned on, the light intensity will be at the level memorised
when it was turned off the time before.
The control lever must be managed very carefully to avoid breakage.
progeCAD 2008 Smart! - Private use only
The remote cable must not be lengthened during installation. Any operation
done on the remote cable could produce negative effects on the "EMC"
performance.
on oFF
SWITCH ON SWITCH OFF
A B