Idiomas disponibles
Idiomas disponibles
enGlisH
Figure 2: Programming Keys
Do not press the reset button again unless you want to completely remove all
your programming .
• Turn the rotary dial to the time/date position.
• 12:00 AM will appear in the display with three arrows pointing to the year,
month, and day [See Figure 3] .
• Press and hold the + button to advance the clock to the correct time of day.
Use the – button to go in reverse . When the correct time of day is reached,
press the enter button to lock in the time . To increase or decrease more
rapidly, hold down either the + or – buttons until the display goes into rapid
advance mode .
• A blinking cursor will appear below the arrow for the year, month, and date
when programming .
• Use the + and – buttons to set the correct year, then press enter.
• Use the + and – buttons to set the correct month, then press enter.
7
• Use the + and – buttons to set the correct date, then press enter.
Figure 3: LCD Display with Surrounding Information
The display will show the correct time and date . After the time of day, date, and
year are set, this procedure does not need to be entered again for any other
programming .
(Note: If a watering schedule is not entered into the controller, the factory
installed fail-safe program will turn on each station every day for 10 minutes. To
avoid accidental station activation, either turn the rotary switch to off or enter a
watering schedule.)
determine a Watering plan
To help you visualize how best to program the controller, it might be helpful
to make a watering plan on paper . This will help you establish which days and
times you want to water .
8
