DeWalt DCT411 Manual De Instrucciones página 18

To Change Default Setup
NOTICE: Changing to default setup will erase current settings
and restore factory settings.
1. Press the main menu button to show the Main Menu.
2. Press the forward or back arrow to select the Default Setup
option.
3. Press the OK button to navigate to the next screen.
4. Press the forward or back arrow to select NO or YES.
5. Press the OK button to save changes and exit.
Operating Tips
• Use only D WALT 12V Max* lithium ion battery.
E
• Ensure the D WALT battery is in good working condition. If the
E
low battery indicator light on the screen is flashing, the battery
needs to be recharged.
• To extend battery life, make sure to turn both the screen and the
handle set off when not in use.
• Make sure the screen is fully charged before operation.
MAINTENANCE
Cleaning
WARNING: Blow dirt and dust off with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Troubleshooting
• Make sure the 12V Max* battery is charged.
• Make sure the screen is fully charged.
• Make sure the screen is always attached to the handle set. The
picture may freeze if you attempt to remove the (screen) from
the handle set while taking a photo or video.
• Make sure the battery is installed on the handle set when in use.
• Make sure the camera cable is attached to the handle set
properly.
• Make sure the handle set is turned on as well as the screen.
• Make sure the back of the handle set is not covered with debris
16