Samsung WA484DSHA Serie Manual Del Usuario página 32

Ocultar thumbs Ver también para WA484DSHA Serie:
Idiomas disponibles

Idiomas disponibles

troubleshooting
PROBLEM
Fills with the wrong
temperature water.
Door locked or will not
open.
Does not drain and/or spin.
Load is too wet at the end
of the cycle.
Leaks water.
Has excessive suds.
32_ troubleshooting
WA484DSHA-03050D_EN.indd Sec8:32
WA484DSHA-03050D_EN.indd Sec8:32
SOLUTION
Turn both faucets on fully.
Make sure the temperature selection is correct.
Make sure the hoses are connected to the correct faucets.
Flush water lines.
Disconnect the hoses and clean the screens. The hose fi lter screens
may be plugged.
As your Washer is fi lling, the water temperature may change as
the automatic temperature control feature checks incoming water
temperature. This is normal.
While your Washer is fi lling, you may notice just hot and/or just
cold water going through the dispenser when you have selected
cold or warm wash temperatures. This is a normal function of the
automatic temperature control feature as your Washer determines the
temperature of the water.
Press the Start/Pause Button to stop your Washer.
Your Washer door will remain locked during the heating portion of the
Sanitize Cycle in case of the water too high.
It may take a few moments for the door lock mechanism to
disengage.
Check the fuse or reset the circuit breaker.
Straighten the drain hoses. Eliminate kinked hoses. If there is a drain
restriction, call for service.
Close the door and press the Start/Pause Button. For your safety,
your Washer will not spin unless the door is closed.
Use the High or Extra High spin speed.
Use high effi ciency detergent to reduce over–sudsing.
The Load is too small. Very small loads (one or two items) may
become unbalanced and not spin out completely.
Make sure all hose connections are tight.
Make sure the end of the drain hose is correctly inserted and secured
to the drainage system.
Avoid overloading.
Use high effi ciency detergent to prevent over–sudsing.
Use high effi ciency detergent to prevent over-sudsing.
Reduce the detergent amount for soft water, small or lightly soiled
loads.
Non-HE detergent is NOT recommended.
2012-07-02
2012-07-02
3:39:28
3:39:28
loading

Este manual también es adecuado para:

Wa476dsha serieWa484dshasu