Idiomas disponibles
Idiomas disponibles
NOTE: This battery is designed to not
operate when a charge below 20% of
its capacity is reached. After the battery
charge is depleted, the tool will not operate
until after the battery has been recharged.
LED Work Light - Figure E
There is a work light (10) located near
the battery fuel gauge (9). The work light
is activated when the trigger switch is
depressed, and will automatically turn
off 20 seconds after the trigger switch
is released. If the trigger switch remains
depressed, the work light will remain on.
NOTE: The work light is for lighting
the immediate work surface and is not
intended to be used as a flashlight.
E
E1
Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
• Unit shuts off abruptly.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
All manuals and user guides at all-guides.com
Accessories Storage
• A bit storage slot (11) is built into the
E2
10
Troubleshooting
Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• Internal components too hot.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
10
base of the tool.
Possible Solution
• Check battery pack
installation.
• Check battery pack
charging requirements.
• Allow tool to cool down.
charger until LED
lights.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• Allow battery pack to cool
down.
• Place on charger and
allow to charge.
