Idiomas disponibles
Idiomas disponibles
Setting the Drilling Depth (Fig. 3)
1. Insert the required drill bit into the chuck.
2. Slacken the side handle (F).
3. Fit the depth adjustment rod (G) through the hole in the side
handle clamp.
4. Adjust the drilling depth as shown.
5. Tighten the side handle.
Forward/Reverse Slider (Fig. 1)
To select forward or reverse rotation, use the forward/reverse
switch (C) (see arrow on tool).
WARNING: Always wait until the motor has come to a
complete standstill before changing the direction of rotation.
Two-Gear Selector (Fig. 4)
This tool is fitted with a two-gear mode selector (D) to vary the
speed/torque ratio.
Release the ON/OFF-switch and select the required position as the
drill coasts to a stop. Always align the selector arrow with the gear
symbol on the gear housing:
1 low speed/high torque
(drilling large holes or driving large screws)
2 high speed/low torque
(smaller holes, drilling in wood)
WARNING: Do not change gears at full speed or during use.
Chuck Removal (Fig. 5)
1. Open the chuck jaws as far as possible.
2. Insert a screwdriver into the chuck and remove the chuck
retaining screw (L) by turning clockwise.
3. Tighten an Allen key into the chuck and strike it with a hammer
as shown.
FIG. 4
FIG. 5
L
8
D
