Idiomas disponibles
Idiomas disponibles
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
wARNiNG: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
CAuTiON: wear appropriate hearing protection during use. under some
conditions and duration of use, noise from this product may contribute to
hearing loss.
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ........................ minutes
current
...................... direct current
.......................... Class II Construction
......................... safety alert symbol
.../min ............... revolutions or
mOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
your tool will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that you tool will operate on standard 60 Hz AC
or DC power. This information is printed on the nameplate. Lower voltage will cause
loss of power and can result in over-heating. All Black & Decker tools are factory-tested;
if this tool does not operate, check the power supply.
Extension Cords
When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier the cord.
Safety warnings and instructions: Sanders
• ALwAYS uSE PROPER EYE AND RESPiRATORY PROTECTiON.
• Clean your tool out periodically.
• Before using the tool on metal workpieces or workpieces containing metal, make sure
to remove the dust canister.
• Wear gloves when
working with metal
workpieces.
Other important
Safety
warnings and
instructions
reciprocations per minute
SAVE ThESE iNSTRuCTiONS
Volts
120V
240V
Ampere Rating
More
Not more
Than
Than
0
-
6
6
-
10
10
-
12
12
-
16
A ......................... amperes
W ........................ watts
.......................alternating
n o ....................... no load speed
........................ earthing terminal
minimum Gauge for Cord Sets
Total Length of Cord in feet
0-25
26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
American Wire Gauge
18
16
18
16
16
16
14
12
4
51-100
101-150
101-200
201-300
16
14
14
12
14
12
Not Recommended
