32
C
leaning and Maintenance
Cold water washing
• If you always use COLD water, we recommend that a WARM or HOT wash be used at a
regular intervals e.g. every 5th wash should be at least a WARM one.
When you have finished
• Turn off taps to prevent the chance of flooding should a hose burst.
• Always unplug the power cord after use.
When water supply into the tub is not clean or the filter is clogged with particles (such as sand), clean the
filter in the inlet valve occasionally.
(The figure of power cord and water tap may vary according to the country)
To Clean the Filter in the Inlet Valve
1
Close the tap before turning off the power.
Select both Hot/Cold and then press the
[START/PAUSE] button to remove water
from the machine completely.
3
After removing the water supply
hose pull out the filter.
Then use a brush to clean the
filter.
Caution
Before cleaning the filter, the impurities in the water supply hose should be removed.
To Clean the Lint Filter
1
Pull out the lint filter from the
tub in the direction shown
below.
Note
If the lint filter is torn or damaged, purchase a new one from LG service center.
2
Turn off the power before
pulling out the cord.
4
Replace the filter after cleaning it.
2
Turn the net inside out to clean
the filter and rinse it with water.
3
Replace- the filter to the original
location. Push the lip of the
filter until a pop sound is heard.