Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan (Downrod)-Continued
6. Route wires and safety cable through motor coupling
cover, canopy trim ring, canopy screw cover and ceiling
canopy. (Figure 6)
7. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires and safety cable
through the hanger ball. Position the pin through the
two holes in the downrod and align the hanger ball so
the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger ball.
A loose set screw could cause fan wobble. (Figure 7)
8. Cut off excess lead wire approximately 6 to 9
inches above top of the downrod. Strip insulation
off 1/2 inch from the end of each lead wire. (Figure 8)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
How to Assemble Your Ceiling Fan (Close-to-Ceiling)
1.
Remove and discard the five rubber motor stops
from the motor assembly by removing the screws.
(Figure 1)
2. Alternating positions, remove three motor coupling
screws from motor assembly and retain the screws
for Step 4. (Figure 2)
Canopy Trim
Ring
Motor Stops
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
8
Ceiling Canopy
Canopy Screw
Cover
Motor Coupling
Cover
Figure 6
Figure 7
Figure 8
Figure 1
Figure 2
