Sanus VisionMount VLL10 Manual De Instrucciones página 6

3
Wood Stud Mounting
3-1
Locate studs
< 16 mm
(5/8 in.)
41 - 61cm
(16 - 24 in.)
3-2
Mark the wall
3-3
Drill pilot holes
3-4
Tighten lag bolts
002534.eps
LF288 / XF288 - Mount to wood stud
[03]
[04]
6
41cm
(16 in.)
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Verify the center of each stud with an awl or thin nail or use an edge
to edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3 in).
Ù
Level the wall plate [01] and mark the hole locations.
[01]
CAUTION:
Pilot holes MUST be drilled to a depth of 70 mm
(2.75 in.), using a 5mm (3/16 in.) diameter drill bit.
Using a drill and the Allen Driver Bit [03] tighten lag bolts [04].
CAUTION:
Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts [04].
Ù
Tighten the lag bolts only until they are pulled firmly against the
Ù
wall plate [01].
[01]
(3/16 in.)
70mm
(2.75 in.)
6901-002034 <05>
5 mm