Placement - Klarstein Happy Hour Manual De Instrucciones

PLACEMENT

• There should be left at least 200 cm³ for ventilation.
• The distance between wall and refrigerator side should be at least 20mm.
• The bottom should be left at least 50mm for air flowing air passing through must not
be preheated.
• Entire cooling system should be considered in the ventilation.
• The following four pictures show four installation ways:
• This refrigerator is designed to be free standing installation only, and should not be
recessed or built-in
• (Fully recessed). Allow 13cm of space between the back and sides of the
refrigerator, which allows the proper air circulation to cool the heat sink.
• Failure to do so can possibly cause the fire.
• Place your refrigerator on a surface that is strong enough to support it when it is
fully loaded.
• Locate the refrigerator away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
• This refrigerator uses thermoelectric refrigeration technology (no compressor) and is
not designed for stor- age in hot areas like garages, warehouses or outdoors since
it is designed to operate at a maximum of 17 below the ambient temperature.
• Avoid locating the unit in moist areas.
• Plug the refrigerator into an exclusive, properly installed-grounded wall outlet.
Do not under any circum- stances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician.
• After plugging the refrigerator into a wall outlet, allow the unit to cool down for 2-3
hours before placing.
EN
11