Idiomas disponibles
Idiomas disponibles
PerfectView CAM604
Therefore, please observe the following instructions:
• As far as possible, use original ducts for laying the cables, or other suitable
options such as panelling edges, ventilation grilles or dummy plugs. If no
openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to emerge.
• Wherever possible, lay cables inside the vehicle, as they are better protected
there than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened
(use additional cable ties, insulating tape etc.).
• To prevent damage to the cables when laying them, ensure that they are far
enough away from hot or moving vehicle components (exhaust pipes, drive
shafts, light systems, fans, heaters, etc.). Use corrugated piping or other
protective materials to protect against mechanical wear.
• Screw on the plug connections for the connecting cables to protect them against
water penetration (fig. 0, page 4).
• When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3, page 3).
• Attach the cables securely in the vehicles to prevent tripping hazards. This can be
performed by using cable binders, insulating tape or gluing in place with
adhesives.
• Protect every through-hole made in the bodywork against water penetration,
e.g. by using a cable with a sealant and by spraying the cable and the cable
sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all
installation work on the camera and have laid the required cable lengths.
EN
Notes on the electrical connection
15
