Idiomas disponibles
Idiomas disponibles
PerfectView CAM604
8.3
Connecting the camera
I
NOTE
• Lay the camera cable so that, should you need to remove the
camera, you can access the plug connection between the camera
and the extension cable easily. This facilitates the disassembly
considerably.
• To minimise corrosion in the plug, apply a small amount of grease,
such as pin grease, in one of the plugs.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable
(not included in scope of delivery, fig. l 1, page 8).
➤ Screw on the plug connection of the connecting cables to protect against water
penetration (fig. 0, page 4).
Connecting the connection box (fig. l, page 8)
8.4
The control box is supplied ready for installation.
➤ Fasten the control box at a suitable point.
I
NOTE
Connect the camera input for close-up (reversing camera) with the "C1"
connection and the camera input for the long-distance with the "C2"
connection.
➤ Connect the control box electrically as follows:
– Connect the camera inputs on the monitor to the "C1" and "C2"
connections.
– Connect the system cable from the camera to the "CAM" connection.
The camera is switched on and off in reverse gear or using the camera selection
button on the monitor.
EN
Fitting the camera
21
