Idiomas disponibles
Idiomas disponibles
Motor Cooling
To avoid overheating and damage to the motor, always keep
the cooling air vents clean and free of sawdust and debris.
Replacing the Guide Bar and Chain
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the batteries are not
inserted in the compartment before proceeding with operation.
m
WARNING!
Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and efficiency of the
machine. If in doubt, contact an authorized Snow Joe
Sun Joe
dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
The operation should be completed on a
flat and stable surface, with adequate space for moving the
machine and its components.
m
DANGER!
Never start the motor before installing the
guide bar, chain, and sprocket cover. Without all these parts in
place, the clutch can fly off or explode, exposing the user to
potentially serious injuries.
When you first purchase your chain saw, the chain and bar will
come pre-assembled on the saw. Should you need to replace
the chain in the future, follow the steps below.
1. Unscrew the end cover + chain tensioning knob
counterclockwise to unlock to the end and remove the
chain/sprocket end cover (Fig. 19).
Fig. 19
Chain/sprocket end cover
2. Remove the cutting bar and chain from the mounting
surface (Fig. 20).
+
®
+ Sun Joe
customer
®
®
End cover +
chain tensioning
knob
16
Fig. 20
3. Remove the old chain from the bar.
4. Lay out the new saw chain in a loop and straighten
any kinks. THE SHARP SIDE OF THE TEETH MUST
FACE AWAY FROM YOU IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR
turn the loop over (Fig. 21).
Fig. 21
Sharp cutting edge
Chain drive link
5. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely fit until it is placed on the sprocket
(Figs. 22 & 23).
NOTE: Make certain of the direction of the chain
backwards, the saw will vibrate abnormally and will
not cut.
Fig. 22
Mounting surface
Guide bar
Cutting
chain
Chain/sprocket
end cover
. If the teeth face backwards,
Chain rotation
. If the chain is mounted
