Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS OF THE TOOL
Pneumatic wrench is a tool that is powered with a stream of compressed air at appropriate pressure. Wrenches installed on a
collector make screwing down and unscrewing possible, particularly where a high turning moment is required. The tool is not
supposed to function in a continuous manner. Correct, reliable and safe functioning of the tool depends on correct operation,
therefore:
Before operation of the tool can be commenced, the whole manual must be read and kept.
The supplier cannot be held responsible for any damages or injuries which are caused by using the tool in a manner that does not
correspond to its purpose, not observing safety regulations or the recommendations of the present instructions. Using the tool in
a manner that does not correspond to its purpose also cancels the guarantee.
EQUIPMENT
The pneumatic wrench is equipped with a connector that facilitates its connection to the pneumatic system.
TECHNICAL DATA
Parameter
Catalogue number
Length
Weight
Diameter of the air connection (PT)
Inside diameter of the air supply hose
Rotations
Maximum turning moment
Size of the collector
Maximum working pressure
Recommended working pressure
Required air fl ow (at 6.3 bar)
Acoustic pressure LpA (ISO 15744)
Acoustic power LwA (ISO 15744)
Vibrations (ISO 28927-2)
GENERAL SAFETY CONDITIONS
WARNING! During operation of a pneumatic tool, it is recommended to always observe the basic safety regulations including
those mentioned below, in order to diminish the risk of fi re, electric shock and injury.
Before operation of the tool can be commenced, the whole manual must be read and kept.
ATTENTION! Read all the instructions mentioned below. If they are not observed, there is a risk of electric shock, fi re or injury.
The notion of „pneumatic tool" that is used in the instructions refers to all tools that are powered with a stream of compressed air
at appropriate pressure.
OBSERVE THE FOLLOWING INSTRUCTIONS
General safety rules
For multiple hazards, read and understand the safety instructions before installing, operating, repairing, maintaining, changing acces-
sories on, or working near the assembly power tool for threaded fasteners. Failure to do so can result in serious bodily injury. Only
qualifi ed and trained operators should install, adjust or use the assembly power tool for threaded fasteners. Do not modify this as-
sembly power tool for threaded fasteners. Modifi cations can reduce the eff ectiveness of safety measures and increase the risks to the
operator. Do not discard the safety instructions; give them to the operator. Do not use the assembly power tool for threaded fasteners if
it has been damaged. Tools shall be inspected periodically to verify that the ratings and markings required by this part of ISO 11148 are
legibly marked on the tool. The employer/user shall contact the manufacturer to obtain replacement marking labels when necessary.
Projectile hazards
Failure of the workpiece, of accessories or even of the inserted tool itself can generate high-velocity projectiles. Always wear
impact-resistant eye protection during the operation of the assembly power tool for threaded fasteners. The grade of protection
required should be assessed for each use. Ensure that the workpiece is securely fi xed.
O R I G I N A L
10
GB
Measurement unit
[mm]
[kg]
[mm / "]
[mm / "]
[min
]
-1
[Nm]
[mm / "]
[MPa]
[MPa]
[l/min]
[dB(A)]
[dB(A)]
[m/s
]
2
I N S T R U C T I O N S
Value
YT-09525
190
2,6
6,3 / 1/4
10 / 3/8
7000
850
12,5 / 1/2
0,6 – 0,8
0,63
119
92 ± 3
103 ± 3
5,47 ± 1,5
