Cameo CLF2FC Manual De Usuario página 12

SLAVE MODE
Starting from the main display, press on the left push button rotary encoder to move to the mode selection menu. Rotate the left encoder
to select the "Slave" menu item (as indicated by selector arrow on left) and confirm by pressing the encoder (ENTER). Slave mode is now
activated and the main display is automatically shown again. Connect the slave and master unit (same model, same software version) using
a DMX cable, and activate one of the stand-alone modes on the master unit. The slave unit will now follow the master unit.
currently activated mode
Press encoder =
select mode
DMX MODE
Starting from the main display, press on the left push button rotary encoder to move to the mode selection menu. Rotate the left encoder
to select the "DMX" menu item (as indicated by selector arrow on left) and confirm by pressing the encoder (ENTER). DMX mode is now
activated and the main display is automatically shown again. Select one of the ten available DMX modes in the menu item "DMX Mode" in
the main menu (see SET DMX MODE).
DEVICE SETTINGS (Settings)
Starting from the main display, press on the right push button rotary encoder to move to the main menu. Rotate the left encoder (SELECT) to select
"Settings" menu item (as indicated by selector arrow on left) and confirm by pressing the left encoder (ENTER). This will take you to the submenu
for setting the submenu options (see table, select via SELECT, confirm via ENTER, change value or status via SELECT, confirm via ENTER).
Settings
Display Flip
Display Time off
DMX Fail
12
= Display rotation
= Display lighting
Operational status with
=
DMX signal fault
Standing Position No rotation of the display
Hanging Position Display is rotated by 180° (e.g. for overhead installation)
Display always on Permanently on
Deactivates after approximately 20 seconds of
Display off after 20s
inactivity
Hold Last command is retained
Blackout Activates blackout
User Color 8 Activates User Colour 8
Fan mode
Press encoder =
Open main menu