RedMax HTZ750 Manual De Usuario página 9

Ocultar thumbs Ver también para HTZ750:
Idiomas disponibles

Idiomas disponibles

2. Push the air purge bulb approximately 6 times or
until the bulb starts to fill with fuel. It is not necessary
to fill the air purge bulb fully.
3. Hold the body of the product on the ground with your
left hand. Do not step on the product.
4. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force.
WARNING:
rope around your hand.
CAUTION:
rope to full extension and do not let go of
the starter rope handle.
5. Continue to pull the starter rope handle until the
engine fires, then push the choke control to its initial
position.
WARNING:
the engine starts.
6. Continue to pull the starter rope handle until the
engine starts.
7. Push and release the throttle trigger to set the
engine to idle speed.
8. Push the throttle trigger gradually to increase the
engine speed.
9. Make sure that the engine runs smoothly.
To start the product with a warm engine
1. Hold the body of the product on the ground with your
left hand. Do not step on the product.
2. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force. Continue
until the engine starts.
Note:
For more information about how to start the
To start the product with a cold engine
product, refer to
on page 8 .
To stop the product
Move the stop switch to the stop position to stop the
engine.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
1075 - 003 - 30.01.2021
Do not wind the starter
Do not pull the starter
The blades move when
Maintenance
Read and understand the
CAUTION:
automatically goes back to run position.
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge.
WARNING:
front of the cutting equipment does not
touch the ground.
2. Adjust the speed to align with the work load.
3. Hold the product near your body for a stable work
position.
4. Be careful and operate the product slowly.
The stop switch
Make sure that the
9
loading