Idiomas disponibles
Idiomas disponibles
Operations
AutoFill Pitcher
(RF28T502***
model only)
40
English
Untitled-1 40
If the Lock indicator ( ) is off, press AutoFill Pitcher turn AutoFill
Pitcher on. Then, open the left door of the fridge and insert the
water tank. Close the door and the water tank starts to fill with
water up to the preset level.
If the Lock Indicator ( ) is on, indicating the Lock function is active,
press and hold Lock for 3 seconds to deactivate the Lock function.
When the Lock indicator turns off, immediately press AutoFill
Pitcher to turn AutoFill Pitcher on. Then, open the left door of the
fridge and insert the water tank. Close the door and the water tank
starts to fill with water up to the preset level.
NOTE
• When you turn off the Lock function, you must press AutoFill
Pitcher within one minute or the Lock function will automatically
reactivate. You cannot turn the AutoFill Pitcher function on if
the Lock function is active. For more information on the Lock
function, see page 43. To turn the function off, press the AutoFill
Pitcher again.
• By default, AutoFill Pitcher is disabled. Enable this function after
you have installed the water line.
•
blinks if you open the door and remove or insert
the pitcher with the AutoFill Pitcher function off. To stop the
blinking, close the door or, turn the AutoFill Pitcher function on.
• The AutoFill Pitcher indicators (
blink if there is a leak. If this is the case, follow these steps.
a. Open the rubber cap and drain water.
b. When draining is complete, the indicators stop blinking and
turn solid.
c. Close the rubber cap.
• If the indicators continue to blink, this might be a system failure.
Contact a local service center.
/
)
2020-06-09 PM 3:20:05
