Place battery box on the cabinet floor
or hang on the cabinet wall (Steps 1-4).
Coloque la caja de las pilas en el piso
del gabinete o cuelgue en la pared del
armario (pasos 1-4).
Placez le boîtier de piles sur le fond de
l'armoire ou accrochez-le sur la paroi de
l'armoire (étapes 1 à 4).
1
2
3
4
18
Operation & Low battery:
Wait 15 seconds after power is applied
for unit to power up. It may take 1 tap
to initialize your dispenser depending
on the position of your spout when
power was applied. Note: To initially
prime your dispenser it may take
several operations depending on the
thickness of your soap. When the
dispenser is operating normally the
LED (1) will illuminate BLUE. When
your batteries are low the LED will flash
RED during operation as a reminder to
replace your batteries. If the dispenser
does not dispense soap and the red
light is flashing, your batteries are no
longer able to operate the pump. If
the dispenser does not dispense soap
and your LED is BLUE, you may need
to refill your dispenser. Note: If you
1
choose to clean the soap bottle,
ensure the electronics do not get wet.
Troubleshooting:
l Red Light with new batteries.
May have one or more
batteries reversed.
l Pump performance poor.
Soap or lotion may be too thick. May
need to increase run time (page 5).
l No Activation / No Light
Spout may not be secure on base
(gap between spout and base).
l Pump turns on when grabbing to
rotate off.
This may occur if you approach
the unit at a slow rate. If unit is in
proximity mode, it will sense your
1
approach and turn on before it can
process the grab. Approach at faster
rate. If desired, hands-free can be
disabled to prevent this as well.
19
