▪ Never put down the equipment before the rotary
accessory has completely stopped. The rotary accessory
may touch the surface, making you lose the control of
the angle grinder;
▪ Make sure that the ventilation slots are not clogged while
operating. Do not place any objects over the slots;
▪ Accessories and workpiece may become too hot during
operation. Avoid touching them, they can cause severe
burns;
▪ Make sure that you don't damage the electrical circuits,
gas and water pipes when operating the equipment.
Any damage to these installations can cause fire,
explosion, electric shock or property damage;
▪ Avoid using the angle grinder on surfaces coated with
paints containing lead or other materials harmful to
health. Any contact or inhalation of dust may cause
allergic reactions and / or breathing disorders. Wear a
mask and work with a dust extraction device if the power
tool allows so;
▪ Materials containing asbestos cannot be worked.
Asbestos is carcinogenic.
Before
performing
cleaning,
changing, repairing and maintenance work, the power cord
must be unplugged from the socket.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool must be carefully cleaned after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
adjusting,
accessories
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Keep all nuts and screws well tightened in order to ensure
a safe operation.
If any components or safety devices are removed for
maintenance
works,
immediately and correctly.
Use only VITO-approved tools for this machine or
technically identical parts. Failure to do so may result in
personal injuries or damages to the angle grinder. If in
doubt, if you lack knowledge or resources, you should
contact an official dealer.
Your angle grinder should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
they
must
be
repositioned