Idiomas disponibles
Idiomas disponibles
English
LUBRICATION
This tool is fitted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil may
reduce the life of blades.
MAINTENANCE INSTRUCTIONS
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
To obtain maximum efficiency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
DISASSEMBLY AND REASSEMBLY
INSTRUCTIONS
Disconnect the machine from the
compressed air supply.
Remove all accessories.
Before disassembling the machine, decompress
the air from the oil tank by loosening and
retightening the screw (9).
At each disassembly of the governor, clean the
spring housing, check the condition of the spring
and re-lubricate it carefully.
The governor has a calibrated spring
which can only be replaced by an original
spare part.
When re-assembling, always position the cylinder
exhaust on the opposite side of the turbine
housing.
03/2015
9 / 36
6159946930_09
Series: B
