Idiomas disponibles
Idiomas disponibles
010900
Turn the shear blades upside down and install it so that
the pins on the tool fit in the hole in the shear blades.
Make sure that the shear blades are set in place securely
as far as they reach the base plate.
1
010901
Place the undercover so that the symbol
is aligned with the symbol
010902
Press the undercover down and turn the undercover
clockwise while pressing it down until the symbol
the label is aligned with the symbol
lever (the undercover is completely locked.).
1
2
010903
At this time, make sure that the locking lever fits in the
groove in the undercover.
Remove the blade cover and then turn on the tool to
check it for proper movement.
1. Undercover
2
2. Locking lever
on the undercover
on the locking lever.
on the locking
1. Groove in the
undercover
2. Locking lever
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
OPERATION
WARNING:
Keep hands away from blades.
•
CAUTION:
Smear the blade before and once per hour during
•
operation using machine oil or similars.
Avoid operating the tool under the scorching
•
sunlight as much as practicable. When operating
the tool, be careful of your physical conditions.
010874
Turn the tool on after adjusting the shearing height and
hold it so that the foot of the tool rest on the ground. Then
gently move the tool forward into the area to be cut.
on
010875
When trimming around curb, fence or trees, move the tool
along them. Be careful for the blade not to contact them.
010876
When trimming sprouts or foliage of a small tree, remove
the base frame from the tool and cut little by little.
Shear big branches to your desired height beforehand
using branch scissors before using this tool.
11
