Idiomas disponibles
Idiomas disponibles
Part 3
ELECTRICAL CONNECTIONS
3-wire connection with a power supply cord
WARNING
- Failure to do so can result in electrical shock, severe
personal injury or death.
Install the power cord as follows:
For power cord installations, Hook the strain relief
over the power cord hole (1
of drawer body. Insert the power cord through the
strain relief and tighten it. (Refer to Figure 7.)
DO NOT install the power cord without a strain relief.
1. Remove the lower 3 screws from the terminal block
and retain them. (Refer to Figure 8.)
2. Insert the 3 screws through each power cord
terminal ring and into the lower terminals of the
terminal block.
Make sure that the center wire (white/neutral) is
connected to the center lower position of the
terminal block.
3. Tighten 3 screws securely into the terminal block.
Do not remove the ground strap connections.
4. Go to page 9.
/
") located below the rear
3
8
Separate Strain Relief
before installation
Assemble the strain relief
to the 1
/
" opening in
3
8
Conduit connection plate
3-wire connection
6
FIGURE 7
FIGURE 8
