Part no
6159946390
Issue no
05
Series no
B
Date
09/2008
Page
10 / 48
This product is designed for removing or
polishing material using abrasives or
polishing attachments. No other use permitted. For
professional use only. Before servicing the power
tool, the supply of compressed air must be
disconnected or shut off.
When disposing of components, lubricants,
e t c . , e n s u r e t h a t t h e r e l e v a n t s a f e t y
procedures are carried out.
The tool is designed for a working pressure of
6.3 bar (90 psig). The compressed air must
b e c l e a n . T h e i n s t a l l a t i o n o f a f i l t e r i s
recommended. For maximum efficiency and
performance, comply with the specification of the
air hose (antistatic hose). (Refer to figure no.1 for
compressed air connection)
ømini mm = 13 (1/2")
To obtain maximum efficiency from the
pneumatic tool, preserve its features and
avoid repeated repairs, a routine inspection and
repair programme are recommended at least every
500 hours, the intervals between the various
inspections depending on the amount of exertion
on the power tool.
For dust extraction, please contact your local
sales.
Check the free speed of the tool at regular
interval s and after each operation or
maintenance task. Remove the abrasive to check
the speed. The maximum allowed speed shown on
the tool must not be exceeded and the vibration
level must not be excessive.
This tool is fitted with blades which can
operate without lubricated air. However, a
small amount of oil allows the tool to provide
full power and lengthens its life.The use of dry air
1
KA11120A - KA11120B - KA11135C4S
KA11060A - KA11060B - KA11075A - KA11075B
INSTRUCTIONS
7 m max.
with no trace of oil may reduce the life of blades.
Risk of icing
Ice can cause continued running after the
start lever has been released. Always use a dry air
supply to avoid the risk of icing.
© Copyright 2008, Desoutter St Herblain France
All rights reserved. Any unauthorized use or
copying of the contents or part thereof is prohibited.
This applies in particular to trademarks, model
denominations, part numbers and drawings. Use
only authorized parts. Any damage or malfunction
caused by the use of unauthorised parts is not
covered by Warranty or Product Liability.
2
3
