Idiomas disponibles
Idiomas disponibles
Operation (continued)
6
Selecting a push button tune
The doorbell (A) has different selectable tunes for
different push buttons (sold separately). The push
button set as the "REAR" push button will only play
"Ding" (one note tune). The push button set as the
"FRONT" push button will play either "Ding-Dong" (two
note tune) or Westminster (eight note tune).
Press and release the "TUNE" button on the
doorbell (A) until the desired tune is heard.
NOTE: All doorbell models are designed to work with up
to 10 wireless push buttons (sold separately).
Doorbell tune
Care and Cleaning
Use a dry cloth to clean the doorbell, sensor, and push button.
Do not use cleaners or polishes.
Do not use any fluids on the doorbell, sensor, and push button.
Troubleshooting
Problem
Possible Cause
The doorbell does
not sound.
Motion sensor
alert
Beep-Beep
The batteries are not
installed correctly.
The batteries are dead.
The doorbell is not
receiving power.
The doorbell and the
sensor or push button
are not synced.
NOTE: All doorbells are designed to play only two
different tunes no matter how many push buttons are used.
Front door push button
(sold separately)
Ding-Dong or Westminster
Solution
Make sure the batteries are installed according to the
diagram inside the sensor and push button.
Check the charge of the sensor and push button batter-
ies and replace them if necessary.
Make sure the plug-in doorbell has power.
Sync the doorbell to the sensor or push button. Only one
sensor or push button may be synced at a time. Repeat
these steps for each sensor or push button.
Press and hold the button on the doorbell until the
doorbell sounds a "Beep-Beep".
Press the button on the bottom of the sensor or the
push button within 30 seconds. The doorbell will
sound a "Beep-Beep" tone to indicate the sensor or
the push button is synced.
Test the sensor as shown in step 5 under Installa-
tion or press the push button to ensure operation.
8
A
Rear door push button
(sold separately)
Ding
