Idiomas disponibles
Idiomas disponibles
Operation (continued)
2
Setting the sensor's day detect
The sensor (B) can be programmed to operate during
the daytime only (DAY ONLY) or both day and night
(DAY/NIGHT).
Remove the battery cover and batteries from
the sensor (B).
Slide the "DAY DETECT" switch to the desired
mode. Replace the batteries and cover.
3
Setting the sensor's range
The "RANGE" control increases and decreases the
sensitivity of the sensor (B) as well as increases and
decreases the distance the sensor (B) will detect
movement.
NOTE: False triggering may happen if the RANGE is set
too high.
Adjust the "RANGE" control to increase (MAX)
or decrease (MIN) the sensitivity.
4
Setting the sensor's on-time
The "ON-TIME" control determines the amount of time
that all motion must be stopped before the sensor (B)
will activate the doorbell (A) again.
Select the "ON-TIME" setting desired:
"TEST" - Motion must be stopped for
10 seconds before reactivation.
"1 MIN" - Motion must be stopped for
1 minute before reactivation.
Setting the wireless push
5
button
The wireless push button (C) has two options for tune
selection: Play the selected "FRONT" door musical
tune or play the "REAR" door designated tune (Ding).
Remove the single jumper (AA) inside the push
button (C) to play the selected musical tune.
Add the single jumper (AA) inside the push
button (C) to play only the Ding tune.
DAY DETECT
DAY
ONLY
RANGE
MAX
SYNC
"5 MIN" - Motion must be stopped for
5 minutes before reactivation.
RANGE
MAX
SYNC
Remove jumper to
set as the "FRONT" door
7
Please contact 1-844-760-3644 for further assistance.
B
DAY/
NIGHT
MIN
B
TEST 1 5
(MINS)
ON-TIME
MIN
B
TEST 1 5
(MINS)
ON-TIME
C
Add jumper to set
as the "REAR" door
HAMPTONBAY.com
AA
