Motor Shaft
Arbre d'entrainement
du moteur
Belt
Eje del motor
Courroie
Correa
2
Four Screws
Quatre vis
Cuatro Tornillos
Agitator
Agitateur
Agitador
End Cap
Bouchon
Tapa del
extremo
Groove
Rainure
Ranura
1
- 48 -
➢ Loop new belt (part number
MC-V390B, Type UB12) around
motor shaft and agitator belt
groove. Make sure belt is routed in
the belt guide as shown. See
illustration for correct belt routing.
➢ Reinstall agitator back into nozzle
by placing end caps into grooves.
➢ After reinstalling the agitator, turn it
by hand to make sure that belt is
not twisted or pinched and that all
rotating parts turn freely.
➢ Place the vacuum in the upright
position standing on the handle.
This will minimize wheel
interference when installing nozzle
bottom plate.
➢ Reinstall nozzle cover by (1)
aligning front edge of the cover with
the nozzle and (2) rotating to
installed position.
➢ Lay unit on floor bottom up with
nozzle flat.
➢ Install the four screws to the nozzle
cover.
➢ Route nozzle hose to hose holder.
Align nozzle hose bracket with
retaining bracket on body and slide
down unit it clicks into place.
➢ Return the vacuum cleaner to the
upright position before plugging
into an electrical outlet.
