Idiomas disponibles
Idiomas disponibles
9. Maintenance
Maintenance, replacement, or repair of the emission control device and
systems may be performed by any non-road engine repair establishment or
individual.
System/Compornent
Air Filter
Fuel Leaks
Fuel Filter
Fuel Line
Spark Plug
Muffler
Muffler Spark Arrester
Cooling System
Screws/Nuts/Bolts
Cylinder Exhaust Port
Make sure that the engine has stopped
and is cool before performing any
service to the blower. Contact with
rotating blower fan or hot muffler may
result in a personal injury.
■ AIR CLEANER
• Never operate the blower without an air
filter or with a deformed or broken filter
element because unfiltered dusty air
will quickly ruin the engine.
• Check the air cleaner before use.
A clogged air filter may increase fuel
consumption while cutting down the
engine power.
• Never clean a paper filter by striking it
with or against another object. The filter
may be damaged and resultant dust
F18
contamination can diminish engine
performance.
CLEANING AIR FILTER:
1. Unscrew 2 knob bolts and remove the
air cleaner cover. Then remove a
prefilter mounted inside the air cleaner
cover.
(1) Knob Bolt
(2) Prefilter
(3) Inner Case
(4) Paper Filter
Procedure
Inspect/Clean
Prefilter
Inspect/Replace
Paper Filter
Inspect/Replace
Inspect/Replace
Inspect/Clean
Inspect/Clean
Inspect/Clean
Inspect/Clean
Inspect/Clean
Tighten
Inspect/Clean
WARNING
Daily
or
25 hours
Before use
✔
✔
✔
✔
✔
✔
✔
2. Wash the prefilter in fresh, non
flammable cleaning solution (ex. warm
soapy water) and then dry.
(Clean the air filter once in a week.)
3. Exchange the paper filter element with
new one in case it has been
contaminated.
WARNING
• This prefilter is dry type.
• Never wash the prefilter in
oleaginous cleaning solution.
• Do not clean a paper filter by striking
it.
■ FUEL FILTER
• A clogged fuel filter may cause poor
acceleration of the engine. Check
periodically to see if the filter is clogged
with dirt. The filter can be taken out of
F19
the fueling port using a small wire hook.
Disconnect the filter assembly from the
fuel pipe and unhook the retainer to
disassemble it. Clean the components
with gasoline.
(1) Screen
(2) Element
(3) Holder
(4) Retainer
EBZ8050/RH
Every
Every
Every
50 hours
100 hours
after
after
after
✔
✔
✔
✔
✔
US-13
U
S
