Idiomas disponibles
Idiomas disponibles
Lamp adjustment
The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
1
CAUTION, HOT LAMP!
Let the lamp cool down for
10 min. Change the lamp by
loosening screws X and Y.
Adjust the lamp position by
turning screws A, B and C.
B
Focusing
Step 1: Loosen the focus button on the underside of the device.
Step 2: Adjust the focus by sliding the lenshousing forward or backward.
Step 3: Tighten the focus button.
Do not operate this device with opened lamp housing!
A
2
C
Beam focus knob
18/39
Strike the lamp, open the shutter and the iris, set
the dimmer intensity onto 100 % and focus the light
on a flat surface (wall). Center the hot-spot (the
brightest part of the beam) using the 3 adjustment
screws "A, B, C". Turn one screw at a time to drag
the hot-spot diagonally across the projected image.
If you cannot detect a hot-spot, adjust the lamp until
the light is even.
To reduce a hot-spot, pull the lamp in by turning all
three screws "A, B, C" clockwise ¼-turn at a time
until the light is evenly distributed.
If the light is brighter around the edge than it is in
the center, or if light output is low, the lamp is too
far back in the reflector. "Push" the lamp out by
turning the screws "A, B, C" counterclockwise ¼-
turn at a time the light is bright and evenly
distributed.
40002600_V_1_0.DOC
