Eaton 5E 500 Manual De Instrucciones página 7

5E500/650/850
1.
220/230/240V AC
2.
4 Outlets with battery backup
4 Prises avec autonomie
4 Tomas con autonomia
4 Tomadas com autonomia
4 Pозеток с батарейной поддержкой
‫עם גיבוי סוללה‬ ‫שקעים‬ 2
5E650DIN/850DIN
1.
220/230/240V AC
2.
3 outlets with battery backup
(1 Schuko + 2 IEC)
3 prises avec autonomie (1 Schuko
+ 2 IEC)
3 tomas con autonomia (1 Schuko
+ 2 IEC)
3 tomadas com autonomia (1 Schuko
+ 2 IEC)
3 розетки с резервным питанием от
батарей (1 Schuko + 2 IEC)
‫עם גיבוי סוללה‬ ‫שקעים‬ 5
(1 Schuko + 2 IEC)
5E1100/1500/2000
1.
220/230/240V AC
2.
6 Outlets with battery backup
6 Prises avec autonomie
6 Tomas con autonomia
6 Tomadas com autonomia
6 Pозеток с батарейной
поддержкой
‫עם גיבוי סוללה‬ ‫שקעים‬ 6
TROUBLE SHOOTING
Symptom
No LED display on the front panel.
Alarm buzzer beeps continuously when AC
supply is normal.
When power failure, back-up time is
shorten.
Mains normal but LED is flashing.
Possible Cause
1. Battery weak.
2. Battery defect.
3. Power switch is not pressed.
Overload of the UPS.
1. Overload of the UPS.
2. Battery voltage is too low.
3. Battery defect or aging
Power cord is loose.
3.
Internet/modem line protection only for USB
models
Protection ligne internet/modem uniquement sur
modèles USB
Protección de línea Internet/modem sólo en los
modelos USB
Proteção de linha de Internet/modem somente
nos modelos USB
Защита интернет и модемной линий только
для USB моделей
‫בלבד‬ ‫הגנת קו אינטרנט/מודם בדגמים בעלי חיבור‬
USB
3.
Internet/modem line protection only for USB
models
Protection ligne internet/modem uniquement sur
modèles USB
Protección de línea Internet/modem sólo en los
modelos USB
Proteção de linha de Internet/modem somente
nos modelos USB
Защита интернет и модемной линий только
для USB моделей
‫בלבד‬ ‫הגנת קו אינטרנט/מודם בדגמים בעלי חיבור‬
USB
3.
Internet/modem line protection
Protection ligne internet/modem
Protección de línea Internet/modem
Proteção de linha de Internet/modem
Защита интернет и модемной линий
‫הגנת קו אינטרנט/מודם‬
4.
Fan
Remedy
1. Charge battery up to 8 hours.
2. Replace with the same type of battery.
3. Press the power switch again.
Verify that the load matches the UPS capability specified in
the spec.
1. Remove some noncritical load.
2. Charge battery 8 hours or more.
3. Replace with the same type of battery.
Reconnect the power cord properly.