Idiomas disponibles
Idiomas disponibles
Tools and Parts
Gather the required tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
Tools Needed
Tape measure
■
Phillips screwdriver
■
Flat-blade screwdriver
■
1
/
" (3 mm) flat-blade
■
8
screwdriver
Level
■
Drill
■
Wrench or pliers
■
Pipe wrench
■
/
" (2.4 cm) combination
15
■
16
wrench
/
" (3.2 mm) drill bit
1
■
8
(for wood floors)
Marker or pencil
■
Parts Supplied
Check that all parts are included.
Propane/Natural Gas Conversion Kit
■
#10 x 1
5
/
" (4.1 cm) screws
■
8
(for mounting anti-tip bracket) (2)
Anti-tip bracket (inside oven cavity)
■
Anti-tip bracket must be securely mounted to the back wall
■
or floor. Thickness of flooring may require longer screws to
anchor bracket to subfloor. Longer screws are available
from your local hardware store.
Parts Needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the "Electrical Requirements"
and "Gas Supply Requirements" sections.
4
INSTALLATION REQUIREMENTS
Pipe-joint compound
■
resistant to Propane gas
3
/
" (4.8 mm) carbide-
■
16
tipped masonry drill bit
(for concrete/ceramic
floors)
Noncorrosive leak-
■
detection solution
For Propane/Natural Gas
■
Conversions
5
/
" (1.6 cm) combination
■
8
wrench
/
" (1 cm) nut driver
3
■
8
9
/
" (7 mm) nut driver
■
32
Masking tape
■
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Do not obstruct flow of combustion and ventilation air.
It is the installer's responsibility to comply with installation
■
clearances specified on the model/serial/rating plate. The
model/serial/rating plate is located behind the oven door
on the top left-hand side of the oven frame.
The range should be located for convenient use in the
■
kitchen.
Recessed installations must provide complete enclosure
■
of the sides and rear of the range.
All openings in the wall or floor where range is to be
■
installed must be sealed.
Cabinet opening dimensions that are shown must be used.
■
Given dimensions are minimum clearances.
The anti-tip bracket must be installed. To install the anti-tip
■
bracket shipped with the range, see the "Install Anti-Tip
Bracket" section.
Grounded electrical supply is required. See the "Electrical
■
Requirements" section.
Proper gas supply connection must be available. See the
■
"Gas Supply Requirements" section.
Contact a qualified floor covering installer to check that the
■
floor covering can withstand at least 200°F (93°C).
Use an insulated pad or
■
range if installing range over carpeting.
IMPORTANT: To avoid damage to your cabinets, check
with your builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate, or sustain other
damage. This oven has been designed in accordance with the
requirements of UL and CSA International and complies with
the maximum allowable wood cabinet temperatures of 194°F
(90°C).
1
/
" (0.64 cm) plywood under
4
