Idiomas disponibles
Idiomas disponibles
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with
a
/
" (1.6 cm) combination wrench to remove.
5
8
NOTE: Do not remove the spring beneath the cap.
A
B
C
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
"ê LP" is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1. Remove burner cap.
2. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
C
X-Large Burner
A. Burner cap
B. Burner base
C. Choke (for use with x-large
burner, propane gas only)
3. Apply masking tape to the end of a
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
Side view before
D
E
Side view after
B
C
D
A
B
/
" (7 mm) nut driver
9
32
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4. Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the
hex area. Replace the Natural gas orifice spud with the
correct Propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct Propane gas
orifice spud ratings and to spud holder card for
proper placement.
Fully insert choke into bottom of X-Large burner base.
Choke should snap into place.
NOTE: Use only for spreader bases marked "XL."
Propane Gas Orifice Spud Chart for Surface Burners
Burner
Color
Rating/Type
15,000
Silver
BTU/
Black/Orange
Stacked*
14.200
Silver
BTU/Ultra/
Stacked*
8.000 BTU/
Red/Orange
Semi
5,000 BTU/
Red/Blue
Auxi
1,200 BTU/
Black/Orange
Stacked/
Simmer*
* Not in all kits/models
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top left-hand side of the oven door for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
D
A
Size
ID
Placement
(mm)
number
1.05
L105
LF
0.32
L32
1.05
L105
LF/RF
0.85
L85
RR/CTR
0.65
L65
LR
0.32
L32
LF (Simmer)
15
