Idiomas disponibles
Idiomas disponibles
Metal Stoppers Only
4. Grid Drain Installation
If present, remove the protective plastic cap from the drain and
discard.
Remove the nut, washer, and gasket from the drain body.
Apply a bead of plumbers putty or other sealant around the
underside of the flange according to the sealant manufacturer's
instructions.
For drains with metal stoppers (K-7124 and K-7127): Close the
drain and rotate the drain body until the logo is positioned
horizontally (as illustrated).
Insert the drain into the drain hole and press into place.
Slide the gasket (tapered side up) onto the drain body.
Side the washer over the threads on the drain body.
Thread the nut up the drain body until snug against the
underside of the lavatory. Use care not to rotate the drain while
tightening the nut.
Using a wrench, tighten the nut.
Remove any excess putty or sealant.
Connect the P-trap to the drain body.
1031177-2-B
With the drain
closed, position
so the logo is
horizontal.
Washer
6
Flange
Drain Body
Gasket
Nut
Kohler Co.
