Schneider Airsystems AM 4-10 E1 Manual De Instrucciones Original página 5

Table of contents
1 General information ..................
2 Scope of delivery ......................
3 Conventional use ......................
4 Technical data ..........................
5 Symbols and their meaning ........
6 Safety instructions ....................
7 Components.............................
8 Commissioning .........................
9 Operation ................................
10 Maintenance.............................
11 Modifying parameters ................
12 Faults ......................................
13 Warnings .................................
14 Circuit diagram .........................
15 Vessel inspections .....................
16 Warranty .................................
1 General information
Observe the safety instructions!
Read the Instruction Manual!
Subject to technical modifications. Figures
(at the start of the Instruction Manual) may
vary from the original.
Document inspections, adjustments and
maintenance work in a maintenance log
book. Specify the name and article number
of the unit when making inquiries. Outside of
Germany, different legal or other require-
ments than those listed here may apply.
Recommendation: have our service partners
perform any repair and maintenance work
(see last page).
2 Scope of delivery
– Compressor with instruction manual
– Service instructions
For variant AM x-10 E1 180/270:
– Compressed air vessel with accompanying
document(s)
For variant AM x-10 E1 180/270 DK600/985:
– Compressed air cold dryer with instruction
manual
3 Conventional use
The compressor is designed exclusively for
generating compressed air up to a maximum
of 10 bar.
The compressor may only be operated when
connected to a standardised pressure vessel
1
with a minimum volume of 180 l and a max-
imum permitted working overpressure of 11
1
bar.
1
Compressed air is only suitable for com-
1
pressed air tools/devices/machines and not
1
for human respiration.
2
Any other type of use is considered contrary
to the intended use.
2
The compressor must not be used in poten-
3
tially explosive areas. Combustible, caustic
3
or toxic gases must not be sucked in!
4
It must not be used outdoors!
5
4 Technical data
6
see Figs. 1a ...1c
7
5 Symbols and their meaning
7
7
Read the Instruction Manual
7
Warning against dangers
Danger of electric shock!
Unit can start up again automati-
1
cally!
Hot surface!
Hand injuries from V-belt drive!
Wear ear protection!
Min./max.
max.
T
[°C]
min.
Min./max. operating temperature
max.
T
min.
[°C]
1
0 24
Min./max. air outlet temperature
max.
T
min.
[°C]
Continuous mode
1
0 24
Residual oil content in air [ppm]
Relative air humidity [%]
Volume flow [l/min]
Compression final pressure [bar]
P
max
Switch-on pressure [bar]
P
min
AM x-10 E1
ambient temperature
GB
1