Tabla de contenido
Idiomas disponibles
Idiomas disponibles
pushed in.
" Aim the positive pole and negative pole of the battery at the battery connector of the mobile phone,
and press the left of the battery to install the battery into the battery tank.
Using code
The mobile phone and the SIM cards support sorts of passwords, in order to prevent the phone and
the SIM cards from being misused. When you are prompted to input any of the codes mentioned below,
just input the correct code and then press the OK key. If you input a wrong code, press the Right soft
key to clear it and then input the correct code.
" Phone lock code
The phone lock code may be set to prevent your mobile phone from being misused. In general, this
code is provided along with the mobile phone by the manufacturer. The initial phone lock code is set to
1234 by the manufacturer. If the phone lock code is set, you need to input the phone lock code when
powering on the mobile phone.
" PIN
The PIN (Personal identification number, 4 to 8 digits) code prevents your SIM card from being used
by unauthorized people. In general, the PIN is supplied with SIM card by the network operator. If PIN
check is enabled, you need to input the PIN each time when you power on your mobile phone. The SIM
card will be locked if you input wrong PIN code for three times.
Unlocking methods as follows:
-Input the correct PUK according to the screen tips to unlock the SIM card.
-Then input the new PIN and press the OK key.
-Input the new PIN again and then press the OK key.
-If the input PUK is correct, the SIM card will be unlocked and the PIN will be reset.
Note: The SIM card will be locked if you input wrong PIN code for three times. To unlock the SIM
card, you need to input the PUK. In general, the PUK can be obtained from the network operator.
" PUK
The PUK code (Personal Unlocking Key) is required to change a blocked PIN. It is supplied with
SIM card. If not, contact your network operator. If you input wrong PUK code for 10 times, SIM card will
be invalid. Please contact the network operator to replace the SIM card.
" Barring code
A barring code is required for setting the call barring function. You can obtain this code from the
network operator to set the call barring function.
Installing T-Flash Card
The T-Flash card is a pluggable mobile storage card inside the mobile phone.
To install the T-Flash card, open its latch, place its indented side downward, insert the card into the
card slot, and then close the latch.
To remove the T-flash card, open its latch and slightly take the card out. And then close the latch.
Note:
1. The mobile phone cannot automatically identify the T-flash card being inserted when the mobile
phone is powered on. You must power off the mobile phone and then power it on, so that the phone can
identify the T-Flash card.
2. The T-Flash card is a miniature object. Keep it out of the reach of children for fear that children
swallow it!
Charging the Battery
The lithium battery delivered with the mobile phone can be put into use immediately after being
P-7
Capítulos
Tabla de contenido
